Velcro base Ø150mm without hole
Velcro base Ø150mm without hole for Originale Zéphyr edgers
The 150 mm diameter Velcro base without holes is a component used to secure the abrasive disc to the machine's support.
Here is its general role and some information on when it may be necessary to change this part:
1. Attaching the sanding disc: The Velcro base is designed to allow the sanding disc to be attached to the machine. The Velcro surface adheres to the back of the sanding disc holder, ensuring a secure hold while sanding the floor.
2. When to change the Velcro base without holes :
- Wear: If the Velcro surface shows signs of wear, such as discoloured areas, tears or reduced adhesion, it may need to be replaced.
- Physical damage: Physical damage, such as large tears or deformation, can affect the ability of the baseplate to hold the abrasive disc firmly.
- Ineffective fastening: If the Velcro base no longer holds the sanding disc securely in place, this can lead to problems during sanding and may require replacement.
- Regular inspection: Even if there are no obvious signs of wear, it is advisable to check the condition of the Velcro base regularly and replace it periodically.
In general, regular maintenance, visual inspection and replacement of worn parts will help to keep your edger running smoothly and prolong its life. If you have any doubts about the condition of the Velcro base without holes, or if you notice any problems when attaching the sanding disc, it is advisable to contact the manufacturer's Repex Floor after-sales service for advice specific to your model.
Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.