Steel panel for Short arm

Steel panel for Short arm  

Steel panel for Short arm: Spare part for Zephyr edger.

The short arm plate on the disc holder is part of the support system that holds the abrasive disc used for sanding parquet in place.

Here is its general role and some information on when it may be necessary to change this part:

1. Sanding disc support: The short arm plate of the disc holder is designed to support the sanding disc used in the sanding process. It helps to hold the disc in place during the operation of the edger.

2. Stability and alignment: This plate also helps to ensure the stability of the disc and maintain its correct alignment during sanding. Proper alignment is essential for uniform, high quality sanding results.

3. When to change the disc holder short arm plate :

   - Wear: If the sheet shows signs of wear such as deformation, cracks, or reduced ability to hold the disc stably, it may need to be replaced.

   - Physical damage: Significant damage, such as fractures or breaks, compromising the stability of the support may require replacement.

   - Incorrect alignment: If the sheet does not align the disc correctly, this may affect the quality of the sanding and require replacement.

- Regular inspection: Even if there are no obvious signs of wear, it is advisable to regularly check the condition of the short arm plate of the disc holder.

It is important to consult the Repex Floor manufacturer of your model of Zephyr plasterboard machine for precise information on the maintenance, replacement and adjustment of the short arm plate of the disc holder. The manufacturer's recommendations may vary depending on the model and year of purchase of your machine. 

In general, regular maintenance, visual inspection and replacement of worn parts will help to keep your edging machine running smoothly and prolong its life.

Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.