Embase velcro Ø150mm 8 holes

Embase velcro Ø150mm 8 holes

Embase velcro Ø150mm 8 holes for Originale Zéphyr light edger

The Velcro base with a diameter of 150 mm and eight holes in an Original Zéphyr light edging machine is used to secure the abrasive disc to the machine's support. Here is its general role and some information on when it may be necessary to change this part:

1. Attaching the sanding disc: The Velcro base with eight holes is designed to allow the sanding disc to be attached to the edger. The Velcro surface adheres to the back of the sanding disc, and the eight holes are generally used to allow dust to escape during sanding.

2. Dust evacuation: The eight holes in the Velcro base allow dust generated during sanding to be drawn through the machine, helping to maintain a clean work area and improve sanding efficiency.

3. When to change the Velcro base with eight holes :

   - Wear: If the Velcro surface shows signs of wear, such as discoloured areas, tears or reduced adhesion, it may need to be replaced.

   - Physical damage: Physical damage, such as large tears or deformation, may affect the ability of the baseplate to hold the abrasive disc firmly in place.

   - Blocked holes: If the holes are obstructed by dust debris or other particles, this can reduce the efficiency of dust removal. In this case, it may be necessary to replace the baseplate.

- Ineffective fixing: If the Velcro base with eight holes is no longer holding the sanding disc in place effectively, this can cause problems during sanding and may need to be replaced.

   - Regular inspection: Even if there are no obvious signs of wear, it is advisable to check the condition of the eight-hole Velcro base regularly and replace it periodically in accordance with the manufacturer's recommendations.

It is important to consult Repex Floor's after-sales service with the year of your plasterer's model to obtain precise information on the maintenance, replacement and adjustment of the eight-hole Velcro base. The manufacturer's recommendations may vary depending on the model and year of design of the machine.

In general, regular maintenance, visual inspection and replacement of worn parts will help to ensure that your edging machine works properly and lasts longer.

Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.