Suction belt Ouragan

Suction belt Ouragan

Suction belt Ouragan sander  

The suction belt is an accessory used in the OURAGAN sander. It is used to transmit the power of the sander motor to the suction mechanism, thus collecting the dust generated during the sanding operation. This belt helps to maintain a clean working environment by sucking up dust particles.

Wear points on the suction belt :
1. Surface wear: The surface of the suction belt can wear over time as a result of continuous rubbing against other sander components. This wear may manifest itself as cracks, fissures or a smooth surface.

2. Tension: The tension of the suction belt must be correctly adjusted to ensure optimum operation of the suction system. A belt that is too tight or too loose can cause operating problems and premature wear.

When to change the part :

The suction belt must be replaced in the following cases:

1. If the surface of the belt shows significant signs of wear, such as cracks, fissures or smooth areas.
2. If the belt is damaged, torn or broken.
3. If the belt is slack or over-tensioned, affecting the correct tension required for the suction system to operate correctly.
4. If the belt shows signs of deformation or twisting, which may also affect the transmission of power to the suction mechanism.

Replacing the suction belt is essential to maintain a clean working environment and to ensure efficient operation of the OURAGAN sander's suction system. A worn or damaged belt can lead to dust collection problems and affect air quality in the workplace. We recommend that you check the condition of the suction belt regularly and replace it as soon as any signs of wear or damage are observed.

Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.