Toothed belt PLO

Toothed belt PLO

Toothed belt PLO for OURAGAN sanding drum 

Function

The PLO toothed belt for the drum is an accessory used in the Ouragan heavy-duty sander. It is used to transmit power from the motor to a sanding drum, which is an essential component for sanding surfaces. This toothed belt is designed with teeth that mesh with the drum to ensure efficient power transmission.

Points of wear on the drum timing belt

1. Notch wear: The notches or teeth on the belt can wear out over time due to continuous friction against the sanding drum. This wear can reduce the efficiency of power transmission, which can lead to a decrease in the performance of the sander.

2. Tension: The tension of the drum timing belt must be correctly adjusted to ensure optimal operation. A belt that is too tight or too loose can cause operational problems and premature wear.

When to replace the part?

The drum timing belt must be replaced in the following cases:

1. If the belt teeth are worn, damaged or show signs of cracks or breaks.

2. If the belt is slack or too tight, affecting the correct tension required for the sanding drum to function properly.

3. If the belt shows signs of deformation or twisting, which can also affect power transmission.

Replacing the drum's toothed belt is essential to maintain the performance of the Ouragan sander and ensure effective sanding. A worn or damaged belt can lead to operational problems and poorer sanding results. It is recommended that you check the condition of the belt regularly and replace it as soon as signs of wear or damage are observed.

Non-contractual photo

Please note that the photos of the parts are not to scale.