Toothed belt PLO

Toothed belt PLO

for OURAGAN sanding drum 

The drum toothed belt PLO​ is an accessory used in the Ouragan heavy-duty sander. It is used to transmit power from the motor to a sanding drum, which is an essential component for sanding surfaces. This toothed belt is designed with notches that mesh with the drum to ensure efficient power transmission.

Wear points on the drum toothed belt :
1. Tooth wear: The teeth of the belt can wear over time as a result of continuous rubbing against the sanding drum. This wear can reduce the efficiency of the power transmission, which in turn can reduce the performance of the sander.

2. Tension: The tension of the drum toothed belt must be correctly adjusted to ensure optimum operation. A belt that is too tight or too loose can cause operating problems and premature wear.

When to change the part :

The toothed drum belt must be replaced in the following cases:

1. If the belt teeth are worn, damaged or show signs of cracking or breaking.
2. If the belt is slack or over-tensioned, affecting the correct tension required for the sanding drum to operate correctly.
3. If the belt shows signs of deformation or twisting, which can also affect power transmission.

Replacing the drum toothed belt is essential to maintain the performance of the Ouragan sander and ensure efficient sanding. A worn or damaged belt can lead to operating problems and poorer sanding results. We recommend that you check the condition of the belt regularly and replace it as soon as any signs of wear or damage are noticed.

Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.