Lever handle spring Mistral

Lever handle spring Mistral

Lever handle spring Mistral for Mistral light sander

Fil Ø 1MM - Ø ext 7MM  

The lever handle spring on the MISTRAL sander, manufactured in the Repex Floor workshops, plays an essential role in the lever handle mechanism. This spring is designed to ensure the correct operation of the kickstand by facilitating its adjustment movement, thus allowing smooth and efficient use of the equipment.

As for when to consider changing this part, there are several indications that a replacement may be necessary:

1. Loss of strength: If the spring loses its initial strength and no longer provides the tension required to hold the landing gear correctly in position, it is recommended that it be replaced.

2. Deformation: Any significant deformation of the spring could alter its effectiveness and lead to problems adjusting the lever-handle. In this case, replacement would be necessary.

3. Excessive wear: If the spring shows obvious signs of wear, such as cracks or bends, it is advisable to replace it to avoid any risk of failure.

It is important to note that the warranty applies exclusively to items sold by Repex Floor or its authorised distributors. Parts manufactured in Repex Floor workshops are also covered by this warranty. Any replacement or repair should be carried out in accordance with the warranty conditions specified by Repex Floor.

Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.