Universal Biosourced Matt Maintenance Oil 5L
Universal Biosourced Matt Maintenance Oil 5L: A complete solution for all water-based oiled floors.
Universal Biosourced Matt Maintenance Oil 5L is designed to preserve and regenerate all types of oiled floors, whether they have been treated on site with traditional or water-based oils, or factory-finished with oil.
Extensive compatibility with all oils
This oil is perfectly compatible with all oiled finishes, including Wax Oil, Parquet Oil and Environment Oil. It is also suitable for factory-oiled surfaces, ensuring optimal protection in all contexts of use.
Quick and easy application
Ready to use, it can be applied directly to clean, dry floors without the need for polishing. It dries quickly, allowing rooms to be used again in just 20 minutes. Its spray format facilitates even application with a microfibre cloth, with a clearly visible application area for optimal control.
An environmentally friendly formula
Its composition contains 85% natural, bio-based and mineral ingredients. It complies with the NF EN 16640 standard with a measured bio-based carbon content of 25%, guaranteeing an eco-responsible approach while offering a high level of effectiveness.
Reliable technical performance
This oil has excellent adhesion to all types of oiled wood. Its regenerating power restores the natural appearance of parquet floors while extending their life. It does not leave a slippery surface, as tested according to Labosport standards, making it a safe solution for high-traffic areas.
Comfortable everyday use
Odourless and requiring no polishing equipment, this oil ensures a simple, quick and pleasant maintenance experience. It can be used for regular maintenance or for localised renovation on matt or natural wooden floors.
Tips for applying bio-based oil-wax to wooden floors
The floor must be bare, clean, dry and sound. If it has a finish (varnish, wax, oil), sand it down to bare wood with 120–150 grit sandpaper, then dust thoroughly.
Mix the oil-wax well before application. Apply a thin coat with a brush (or short-bristle roller) in the direction of the wood grain. Wipe off any excess immediately, especially in the joints. For the edges, use a brush and then smooth with a roller.
Two coats are usually sufficient, with 4 hours drying time between coats. A third coat can be applied in high-traffic areas. Before each new coat, sand lightly (150–240 grit) and then dust. Complete hardening takes 10 to 20 days; avoid rugs, water and heavy furniture during this period.
After application, place a doormat at the entrance and avoid contact with water for the first few days. For maintenance, dust regularly and clean with a slightly damp mop and mild detergent.
Manufacturer's product sheet
Non-contractual photo 📷
Please note that the photos of the items are not to scale.
