Four-pole contactor
Four-pole contactor for CYCLONE MAJOR OURAGAN TORNADE TYPHON2 sanders
The tetrapolar contactor in a sander plays an essential role in controlling the electrical circuit. Its main function is to allow or interrupt the flow of electricity to the sander motor. In other words, it acts as an electrical switch to start or stop the machine.
When it's time to change the tetrapolar contactor depends on a number of factors, including general wear and tear on the part, signs of malfunction such as false contacts, unexpected interruptions to the power supply, or any failure in the starting mechanism. Here are some common signs that the tetrapolar contactor may need replacing:
1. Visible wear: If you see signs of wear such as arcing, visible damage or worn contacts on the contactor, it may be time to replace it.
2. Starting malfunction: If the sander has difficulty starting consistently, or if starting is intermittent, the four-pole contactor may be at fault.
3. Unexpected interruptions: If the sander stops unexpectedly during use, this may indicate problems with the four-pole contactor.
It is important to note that the replacement of parts, including the tetrapolar contactor, should be carried out in accordance with the recommendations of the manufacturer of your Repex Floor sander. If Repex Floor replacement parts are specifically designed for your sander, following the manufacturer's instructions and using genuine replacement parts can help to ensure the safe and correct operation of your electrical equipment.
If you experience any problems with the tetrapolar contactor on your sander, it is recommended that you contact our manufacturer's service department or a qualified professional for advice specific to your situation.
Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.