Motor pulley Mistral

Motor pulley Mistral

Motor pulley Mistral​ for Mistral light sander

The motor pulley in the motor section of a sander plays an essential role in the power transmission mechanism. It is designed to receive energy from the motor and transmit it efficiently to the sanding components, such as the sanding plate. The motor pulley thus converts the motor's energy into rotary motion to drive the sanding process.

When it's time to change the motor pulley depends on a number of factors, including general wear and tear on the component, signs of misalignment, abnormal noises during operation, or any irregularities in the power transmission. Here are some common signs that the engine pulley may need replacing:

1. Visible wear: If you notice signs of wear such as deep gouges, deformation or visible damage to the pulley, it may be time to replace it.

2. Abnormal noise: Unusual noises, such as rattles or squeaks, during operation of the sander may indicate problems with the motor pulley.

3. Transmission malfunction: If you observe problems such as intermittent stopping of the sanding table or a loss of power during use, the motor pulley could be to blame.

It is important to note that the replacement of parts, including the motor pulley, should be carried out in accordance with the Repex Floor manufacturer's recommendations. While Repex Floor spare parts are specifically designed for our sanders, following the manufacturer's instructions and using genuine replacement parts can help ensure the smooth operation and durability of your equipment.

If you notice any problems with the motor pulley on your sander, it is recommended that you contact the after-sales service or a qualified professional for advice specific to your situation.

Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.