» Mistral Stand spring

Mistral Stand spring

Reference -2005

Rating:0 opinion

8.37€ Excluding VAT

Mistral Stand spring 20051

Quantity :

Product available

Add to cart

Ask an estimate

E-mail

Mistral Stand spring

Notice

Mistral Stand spring

Mistral Stand spring for Mistral light sander

Wire Ø 1MM - Ø ext 7MM

Function

The Mistral Stand spring, manufactured in the Repex Floor workshops, plays an essential role in the stand mechanism. This spring is designed to ensure the proper functioning of the stand by facilitating its adjustment movement, thus allowing smooth and efficient use of the equipment.

Wear and replacement

As for when to consider replacing this part, there are several signs that may indicate the need for replacement:

1. Loss of resistance: If the spring loses its initial resistance and no longer provides the tension necessary to hold the stand correctly in position, it is recommended that it be replaced.

2. Deformation: Any noticeable deformation of the spring could impair its effectiveness and cause problems with adjusting the kickstand. In this case, replacement would be necessary.

3. Excessive wear: If the spring shows obvious signs of wear, such as cracks or kinks, it is advisable to replace it to avoid any risk of failure.

It is important to note that the warranty applies exclusively to items sold by Repex Floor or its authorised distributors. Parts manufactured in Repex Floor workshops are also covered by this warranty. Any replacement or repair should be carried out in accordance with the warranty conditions specified by Repex Floor.

Non-contractual photo 📷

Please note that the photos of the parts are not to scale.

Mistral Stand spring

Notice

Reviews about this Mistral Stand spring (0 reviews)

There is no review for this item.