Gland nut

Gland nut 

Gland nut for 4D single disc sander

The gland nut on a 4D single disc sander is a mechanical part used to secure and seal the power cable where it enters the sander housing. The gland is an essential part that provides a seal between the cable and the housing, preventing dust, debris and moisture from entering the interior of the sander.

The main function of the gland nut is to protect and secure the electrical connection between the power cable and the sander housing. This prevents electrical problems, short circuits and the risk of electrocution.

When to change the gland nut depends on its physical condition and its effectiveness in fulfilling its protective and sealing function. Here are some signs that it's time to replace it:
Visible wear: if the nut shows cracks, deformation, corrosion or other visible damage, it must be replaced to ensure a proper seal.

2. Loss of fastening: if the nut no longer tightens properly or becomes loose, this may compromise the tightness and safety of the electrical connection.

3. Deterioration of the seal: if you notice that particles of dust or moisture are penetrating inside the enclosure despite the presence of the gland nut, this may indicate that the seal is defective and needs to be replaced.

4. Electrical problems: electrical malfunctions such as power cuts or power fluctuations may be caused by a faulty gland nut.

To avoid any potential problems, it is advisable to include regular inspection of the gland nut as part of the 4D single disc sander maintenance routine. The gland nut should be replaced as soon as you notice any signs of wear or failure, to maintain the safety and optimum performance of the sander.

Be sure to refer to the Repex instructions for specific information on replacing this part or to order a replacement part approved by the manufacturer to ensure tool compatibility and safety.

Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.