Motor cover

Motor cover

Motor cover​ for the Originale BLE edger

The motor cover of the Originale BLE edger is a part that protects the edging machine motor and holds the internal components in place. It performs several important functions:

1. Motor protection: The motor cover protects the flanging machine motor from dust, dirt, debris and moisture. This helps to prolong the life of the motor by keeping it clean and in good working order.

2. Safety: It also protects users of the edging machine by preventing accidental contact with moving engine parts, thereby reducing the risk of injury.

Wear points on the engine cover of the Originale BLE flanging machine depend on the environment in which the machine is used, the frequency of use and the general maintenance of the machine. Here are some signs that this part may need changing:

1. Visible wear: If you notice cracks, chips, deformation or other obvious signs of wear on the cover, it's time to replace it.

2. Loss of structural integrity: If the bonnet is no longer holding internal components correctly in place, or if it is damaged to the extent that its function as an engine protector is compromised, it should be replaced.

3. Loss of seal: If the cover no longer provides an adequate seal and moisture or dust can get inside, it must be replaced to prevent damage to the motor.

4. Compliance with safety standards: If the bonnet has any defects that no longer comply with current safety standards, it must be replaced to ensure user safety.

To sum up, the engine cover of the Originale BLE edging machine is an essential part of the engine's protection and user safety. It should be inspected regularly, and if it shows signs of wear, damage or loss of integrity, it is recommended that it be replaced to keep the machine running safely. Specific replacement recommendations may vary depending on the model of edger and the manufacturer's instructions repex Floor.

Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.