Complete disc holder Zephyr

Complete disc holder Zephyr

Complete disc holder Zephyr edger

The complete disc holder for the Zephyr edger refers to a part that supports and holds in place the abrasive disc used for sanding parquet.

Here is its general role and a few indications as to when it may be necessary to change this part:

1. Sanding disc holder: The complete disc holder acts as the main support for the sanding disc used in the sanding process. It is designed to hold the disc firmly in place while allowing it to rotate during operation of the edger.

2. Stability and fit : The Complete Disc Holder helps to ensure the stability of the abrasive disc during the sanding process. It can also be designed to allow adjustments to adapt the position of the disc to specific sanding requirements.

3. When to change the complete disc holder :

   - Wear: If the Complete Disc Holder shows signs of wear such as cracks, deformation or reduced ability to hold the disc in place, it may need to be replaced.

- Serious damage: Significant damage, such as fractures or breaks, may compromise the stability of the holder and require replacement.

   - Excessive play: Excessive play in the complete disc holder can affect sanding accuracy. If you observe abnormal play or unwanted movement, consider replacing the part.

In general, regular maintenance, visual inspection and replacement of worn parts will help keep your edger running smoothly and prolong its life. If you have any doubts about the condition of the complete disc holder or are experiencing sanding problems, it is recommended that you contact the manufacturer's Repex Floor after-sales service for advice specific to your model.

Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.