Base
Base: Aluminium suction cage for Zephyr edging machine
The aluminium suction cage base of the Zephyr edging machine is an essential component of the machine used for woodworking, particularly for the process of poaching steps and corners.
1. Main functions :
- Chip suction: The suction cage base is designed to collect wood chips generated during the planing or planing operation. It ensures efficient removal of wood debris, helping to keep the workshop clean.
2. Wear points :
- Aluminium wear: Over time and with use, the aluminium of the baseplate can suffer wear due to chip friction and abrasion. This wear can manifest itself as scratches, dents or a loss of rigidity in the part.
- Blockage or obstruction: Wood chips or debris can accumulate in the baseplate, which can cause the suction to block and reduce its efficiency.
- Corrosion: Although aluminium is resistant to corrosion, it can still be affected by moisture or chemicals in wood chips. Corrosion can cause the part to deteriorate.
3. When to change the part:
- You should consider changing the flange machine's aluminium suction cage base when you see obvious signs of wear, such as large dents, deep scratches or loss of rigidity.
- If the base is seriously clogged and this affects the machine's suction capacity, it may also need to be replaced.
- If corrosion is severe and compromises the integrity of the baseplate, it is advisable to replace it to avoid any risk of failure.
It is important to follow the Repex Floor edging machine manufacturer's recommendations for maintenance and replacement of parts, as this may vary depending on the specific model and conditions of use. Regular maintenance and proper replacement of worn parts will help to maintain the machine's performance and safety.
Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.