Base plate
Base plate: Aluminium suction cage for Zephyr edge sander
The base plate of the aluminium suction cage on the Zephyr edge sander is an essential component of the sander, particularly for sanding steps and corners.
Main functions
- Chip extraction: The suction cage base is designed to collect wood chips generated during planing or jointing operations. It ensures efficient removal of wood debris, helping to keep the workshop clean.
Wear points
- Aluminium wear: Over time and with use, the aluminium of the base plate may suffer wear due to friction from chips and abrasion. This wear may manifest itself in the form of scratches, dents or loss of rigidity of the part.
- Blockage or obstruction: Wood chips or debris can accumulate in the base, which can block the suction and reduce its effectiveness.
- Corrosion: Although aluminium is resistant to corrosion, it can still be affected by moisture or chemicals present in wood chips. Corrosion can cause the part to deteriorate.
When should the part be replaced?
You should consider replacing the aluminium suction cage base on the edge trimmer when you see obvious signs of wear, such as significant dents, deep scratches or loss of rigidity.
If the base plate is seriously clogged and this affects the suction capacity of the machine, it may also need to be replaced.
If corrosion is severe and compromises the integrity of the base, it is advisable to replace it to avoid any risk of failure.
It is important to follow the Repex Floor edger manufacturer's recommendations for maintenance and replacement of parts, as this may vary depending on the specific model and conditions of use. Regular maintenance and proper replacement of worn parts will help maintain the performance and safety of the machine.
Non-contractual photo 📷
Please note that the photos of the parts are not to scale.
