Ball joint
For MAJOR sander
The Ball joint of the belt sander's tensioning roller is a part that allows the tensioning roller to be attached to the belt sander's tensioning mechanism.
Its main function is as follows:
1. To allow articulated movement: The ball-and-socket joint allows the tensioning roller to pivot and adapt to variations in the tension of the sanding belt. It ensures uniform contact between the sanding belt and the workpiece, whatever the angle of inclination of the belt sander.
Potential points of wear on the ball end of the tensioning roller can include:
1. Contact surface wear: Surfaces of the ball end that come into contact with other components of the tensioning mechanism may wear over time due to constant friction. This can lead to excessive play or less smooth operation.
2. Structural damage: If the rod-end is subjected to excessive stress, impact or torsion, it may suffer damage such as cracks, deformation or breakage.
If you notice any of the following signs, you will need to replace the ball-and-socket joint on the belt grinder's tension roller:
1. Excessive play or abnormal movement: If the ball end has excessive play that affects the stability of the tensioning roller, or if you notice any abnormal movement during operation, it must be replaced to ensure uniform and efficient sanding.
2. Visible wear: If you notice that the surfaces of the ball end are worn, damaged or show obvious signs of deterioration, it is time to replace it to avoid failure of the tensioning mechanism.
3. Difficulty adjusting tension: If the ball joint makes it difficult or impossible to adjust the tension of the sanding belt, it must be replaced to allow proper adjustment.
It is important to follow the recommendations of the Repex Floor manufacturer of your belt sander for the replacement of the ball joint specific to your model. Keeping this part in good condition will help ensure smooth operation of the belt sander and optimum sanding results.
Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.
.png "logo-Repex Floor"){kind=logo}
.png "logo-Repex Floor"){kind=logo}
