3-phase male connector strip 7 pins

3-phase male connector strip 7 pins

For Ouragan sander

The 3-phase male connector strip 7 pins is an accessory for use with the Ouragan heavy-duty sander. It is used to establish the electrical connection between the sander and a three-phase power source fitted with corresponding sockets. It converts the electrical connection of the sander to make it compatible with three-phase 7-pin sockets.

Wear points on the three-phase connection strip :
1. Electrical connectors: The connectors at the end of the terminal strip may wear over time due to frequent connections and normal wear and tear. The connectors should be checked regularly for signs of wear, corrosion or poor contact.

2. Material and insulation: The whole terminal strip should be inspected to ensure that it is free from damage, cracks or deterioration of the insulation that could expose the wires.

When to change the part :

The male 7-pin three-phase terminal strip must be replaced in the following cases:

1. If the electrical connectors are damaged, corroded or do not provide a reliable connection.
2. If the material or insulation of the terminal strip is damaged, exposing the lead wires.

It is essential to replace the terminal strip as soon as any signs of wear or damage are observed. This ensures a safe electrical connection between the sander and the three-phase power source, which is crucial to the safety of the user and the performance of the power tool on site.

Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.