Flat spanner 21

Flat spanner 21

for OURAGAN sander  

The Flat spanner 21 is one of the OURAGAN sander accessories and is generally used to loosen or tighten the nuts, bolts or screws that hold the sander's components in place. It is used for assembly, disassembly and maintenance of the machine.

Wear points for the Flat spanner 21 :
1. Edge and surface wear: The edges of the open-end spanner may wear over time due to repeated contact with nuts or bolts. The surfaces of the spanner may also show signs of wear, such as scratches or damage.

2. Deformation or damage: A flat spanner that has been abused or used incorrectly can deform or crack, reducing its effectiveness.

When to change the part :

The Flat spanner 21 must be replaced in the following cases:

1. If the edges of the spanner are too worn and no longer provide an effective grip on nuts or bolts.
2. If the spanner shows signs of deformation, cracks or other damage that make it unusable or unreliable.

Replacing the open-end spanner is essential for effective maintenance and repair of the OURAGAN sander. A worn or damaged spanner can make it difficult to loosen or tighten machine components and can even cause safety problems during use. We recommend that you regularly check the condition of the open-end spanner and replace it as soon as any signs of wear or damage are noticed.

Non contractual photo 📷
Please note that the photos of the parts do not use the same scale.